resetting canon pixma mx330 ink cartridges

Look at all those ribbons and make sure none are loose or disconnected and that no metal on the ribbons is showing. If you don’t want to take the printer apart, the top part of the printer where the power, wifi, stop, black, and color buttons are that leftside panels pops off (not easily -.-) but you can see several ribbons in there. They told me to go through several undulations to fake the printer into believing the cart was full. Sent an email to company and the reply was that Cannon will not allow this company to reset the ink level in the cart. No error codes, no jams, just perfect printing. 1PK PG-210XL refilled Black Ink Cartridge for Canon PIXMA MX320 MX330 Printer. Tried the printer again and voila! It finally works. So i gently but firmly wiggled and pushed the cable into place to make sure no metal contacts were showing. Now the printer has POWER!!! I go to try and print and now i get the error 5011… I started looking around again and realized the larger ribbon for the scanner is slightly loose (I could see the metal contacts on the ribbon) which means it wasn’t fully grounded into the slot.

I finally reattached the two ribbons and hooked the printer back up whilst still partially apart. The two ribbons that attach to the top part where the scanner is are for the scanner which is a wide ribbon and a very small ribbon that goes to the power button. Remanufactured Canon PG-240XL Black ink cartridge, High Yield. buy 2+ for 15.95 each (save 10) more details. The base or printer part can be completely separated from the top scanner part. Remanufactured Canon PG-240 Black ink cartridge. The whole scanner part of the machine lifts of with a few ribbon cable attached. I realized I couldn’t reach the sensor or get inside too well so i closed it back up. Being a techy guy I unscrewed the two screws on the back topside of the machine and lifted from the back. The sensor kept tripping i believe on the right side of the paper feed all the way at the base of the machine. I was trying to use my printer this morning and the printer kept “jamming” even though the paper was flat as can be going in and being yanked out. I will share my situation and what i did to fix it. I would like to note I do not know if everyone is having the same exact problem as me.

Hello there fellow users! I’ve spent the past two hours trying to tear this thing apart and fix and have finally succeeded.

Resetting canon pixma mx330 ink cartridges